Variable Name: PRM_2901

Variable ID: 0x42C4

Variable Label: EM6 Error code

Variable Help: The control unit checks the combined sensor (EM6) during the automatically performed self test. In case of an error the indication 'Combisensor failure' is activated. This parameter describes which kind of error was detected. The EM6 is checked in several steps which generate different error code groups. Errors during general communication with EM6: 101 - no communication possible with remote EM6 102 - no communication possible with remote EM6 103 - no communication possible with remote EM6 104 - no communication possible with remote EM6 105 - no communication possible with remote EM6 106 - reference voltage is not valid 107 - communication to remote EM6 is lost 108 - reference voltage is no longer valid 109 - critical communication error with EM6 The non-volatile memory of the combined sensor EM6 is checked in regular intervals. Detected errors are coded as follows: 1 - Read error of serial number 2 - Read error of offset of angle 3 - Read error of correction factor for analogue values 4 - Read error of closing direction 5 - Read error of torque value 6 - Read error of LEARN values 7 - Read error of checksum flag Errors with wall mounted unit: 11 - Read error of serial number 12 - Read error of serial number of board DiM-06 13 - Read error of part number of board DiM-06 14 - Read error of closing direction 15 - Read error of torque value 16 - Read error of LEARN values

Variable Handling: R

Variable Class: Device

Variable Size: 1

Variable DataType: Unsigned

Variable Display Format:

Variable Edit Format:

Variable Unit:

Variable Max: N/A

Variable Min: N/A

Variable Read Command List

Command Number	Command ID	Command Name
160	443F	cmd160_read_prm

Variable Write Command List

None