Loading…
Name ID Label Description Type Access Class
var_dd_eDOValue 4046 Digital Out State R Enum 1026
var_dd_eDOMode 4047 Digital Out Mode R/W Enum 1026
var_ds_eDOTestValue 4048 Digital Out Test State R/W Enum 1024
var_dd_eDIValue 4049 Digital In State R Enum 1026
var_dd_eDIMode 404A Digital In Mode R/W Enum 1026
var_ds_eDITestValue 404B Digital In Test State R/W Enum 1024
var_ds_uiResponseDelay 404C Meas Delay Time Meas Delay Time If interference radiation detection is enabled, the measured values are output with a delay. The delay is adjustable from 0 to 5 seconds. The delay is required so that at the moment of detection the measured value remains unaffected, because in this case, increased count rates are already present which may distort the measured value. R/W Unsigned 2048
var_ds_fIoFactor 404E Io Factor Io Factor Defines the threshold where the interference radiation detection responds. With the default value of 1.5, the threshold is 1.5 times the active empty count rate and is suitable for most applications. You can adjust the factor for the threshold yourself. Note that a value below 1.5 may trigger faulty switching caused by fluctuations in the measured values. Increasing the factor decreases the sensitivity. Increase the factor if false alarms are triggered by significant fluctuations in the measured values, for example, by agitator blades. R/W Float 2048
var_ds_fWaitingTime 404F Waiting Time Waiting Time If interference radiation is detected, the measurement is "frozen" and will be released at the earliest after the waiting period is over. You have to enter the value for the waiting time in seconds. R/W Float 2048
var_dd_eCpsAverageMode 4050 Cps Average Mode Cps Average Mode Select cps average mode. Select 'Fix Value' for test. R/W Enum 2050
Name ID Label Description Type Access Class