Loading…
Name ID Label Description Type Access Class
var_ds_ascLicenseKey5 400A License Key Part5 R/W ASCII 2048
var_dd_dtActiveDate 400B Date Date Enter here the current date. The date is necessary for the proper work of the decay compensation and also for the error log and modification log, to know at which day the error or a parameter modification happened. R/W HartDate 10
var_dd_ascActiveTime 400C Time Time Enter here the current time. The time is necessary for the error log and modification log, to know at which time the error or a parameter modification happened. R/W ASCII 10
var_dd_eOperatingMode 400D Operating Mode Operating Mode RUN The measurement is in the normal measurement mode. WARNING A warning message has appeared. The error code is indicated in "Sensor Settings". ERROR An error is indicated. The error code is displayed in "Sensor Settings". SHUTDOWN A serious error is indicated. The error code is displayed in "Sensor Settings". HOLD The measurement is in the hold state, which means that the measured value and the current output signal is frozen. This status can occur under the following conditions: - the plateau recording is running - interference radiation was detected - the digital input is on Hold TEST A test value is enabled. R Enum 2051
var_dd_eSafetyMode 400E Safety Mode Safety Mode Indicates whether the safety mode is enabled: ON Safety mode is enabled. OFF Safety mode is disabled. R/W Enum 2050
var_ls_eSafetyModeOff 400F R/W Enum 4096
var_ls_eSafetyModeOn 4010 R/W Enum 4096
var_ds_eErrorHandling 4011 Error Handling Error Handling Here you can set a different weighting of errors and error handling: SENSITIVE All faults cause the current output to report a Fault current. To also get warning messages, you must also evaluate the messages via the HART® signal or the digital output. NORMAL Only fatal errors are reported as a fault current. Thus, the measured via the current signal will fail only if the measurement can no longer be used. To also get minor error and warning messages, you must also evaluate the messages via the HART® signal or the digital output. R/W Enum 8
var_ds_eResetDevice 4012 Reset Device R/W Enum 8
var_ds_uiChangeLogIndex 4013 Mod Log Index Mod Log Index Active Index of modification log entry R/W Unsigned 2048
Name ID Label Description Type Access Class