Loading…
Loading…
| Name | ID | Label | Description | Type | Source |
|---|---|---|---|---|---|
| low_point_calibration | 4011 | Low Point Cal | Lower Point Calibration - Calibration method which allows the user to calibrate the lower end of the tank when a level is known. Capacitance at the known lower level is calculated by the transmitter. | msrc_UNKNOWN | Details |
| hi_point_calibration | 4012 | Hi Point Cal | Upper Point Calibration - Calibration method which allows the user to calibrate the upper end of the tank when a level is known. Capacitance at the known upper level is calculated by the transmitter. | msrc_UNKNOWN | Details |
| meter_calibration | 4002 | Meter Config | Meter Calibration - Calibration method which allows the user to calibrate the Minimum and Maximum range of the Digital Meter. | msrc_UNKNOWN | Details |
| analog_loop_assign | 400C | Chg Anlg Loop Asgn | Change Analog Loop Assign - Allows user to select the active analog channel as Level or Vessel. | msrc_UNKNOWN | Details |
| strapping_table | 4003 | Strapping Table | Strapping Table - Method allowing the user to enter input and output points defining the tank in use for calculating the corresponding Digital Values. | msrc_UNKNOWN | Details |
| return_to_normal | 1016 | Aborting return to normal | msrc_UNKNOWN | Details | |
| warning_message | 1017 | Set loop to manual | msrc_UNKNOWN | Details | |
| loop_test | 1002 | Loop test | Loop test- Allows the User to manually manipulate the Analog Output to a selected constant output value | msrc_UNKNOWN | Details |
| leave_fixed_current_mode | 1003 | Leaving fixed crnt mode | Leaving Fixed Current Mode- Takes the Analog Output out of a mode where the output was a constant value, and returns the output to a mode where the output tracks the input | msrc_UNKNOWN | Details |
| dac_trim | 1004 | D/A trim | Digital to Analog Trim- Allows the calibration of a selected Analog Output with an external reference at the operating endpoints of the Analog Output | msrc_UNKNOWN | Details |
| applied_rerange | 1007 | Apply values | Applied values- Perform a device rerange by applying the desired Upper Range Value and Lower Range Values to the device input | msrc_UNKNOWN | Details |
| Name | ID | Label | Description | Type | Source |