变量名称： var_dd_uiInstructDescriptor

变量ID： 0x4021

变量标签： Instruction Code

变量描述：

变量处理： 读

变量分类： 动态 | 诊断

变量长度： 4

变量数据类型： 枚举

变量枚举值	变量枚举文本
0x0000	No instruction needed!
0x0001	1.Change - Electronics 2.Contact BT service
0x0002	1.Restart device 2.Change - Electronics 3.Contact BT service
0x0003	1.Restart device 2.Check - PMT connector - PMT detector unit - Electronics 3.Contact BT service
0x0004	1.Restart device 2.Check - EMC environment 3.Contact BT service
0x0005	1.Check - Detector temperature environment - Temperature alarm setup
0x0006	1.Check - Process - Process alarm setup
0x0007	1.Check - Detector settings - PMT connector - PMT detector unit - Electronics 2.Restart 3.Contact BT service
0x0008	1.Acknowledge event 2.Retry download 3.Try another file
0x0009	1.Retry download 2.Use calibration wizard for new configuration 3.Upload new configuration
0x000A	1.Acknowledge event 2.Restart 3.Check - Try to set Date/Time 4. Contact BT service
0x000B	1.Wait download... it will be finished automatically.
0x000C	1.Wait sampling... it will be finished automatically.
0x000D	1.Wait plateau measurement... it will be finished automatically.
0x000E	1.Wait calibration... it will be finished automatically.
0x000F	1.Exit simulation mode
0x0010	1.Check - Detector calibration - Pulse rate - Range values - Influence of radiation interference 2.Contact BT service
0x0011	1.Check - Detector calibration 2.Contact BT service
0x0012	1.This is a notifcation to check the activated alarm setup after a new calibration has been performed 1.Check device alarm setup 2.Acknowledge event
0x0013	1.Calibrate device by using the Quick Start Wizard
0x0014	1.Acknowledge event 2.Check actual measurement configuration 3.Run new calibration
0x0015	1.Acknowledge event 2.Run new calibration 3.Contact BT service
0x0016
0x0017
0x0018
0x0019
0x001A
0x001B	1.Reboot device 2.Change electronics
0x001C	1.Check - Configuration 2.Restart 3.Change electronics
0x001D	1.Restart device 2.Contact BT service
0x001E	1.Run factory reset 2.Run reboot
0x001F

变量显示格式：

变量编辑格式：

变量单位：

变量最大值： N/A

变量最小值： N/A

变量读取命令列表

命令号	命令ID	命令名称
143	4409	cmd_rd_error_info

变量写入命令列表

无