Variable Name: var_ds_fHVDefault

Variable ID: 0x402E

Variable Label: HV Default

Variable Help: HV Default This setting affects: - A quick operation point control after power failure After a power failure, the HV starts at the last "HV Average" value which results from the "HV Default". This will significantly reduce the start-up phase after power failure. - Error detection in case of HV-drift If the HV deviates too far (+40%, -20%) from the HV Default or if the HV reaches the limits of the range of 300 V or 1300 V, this is reported as an error. - Special feature: 0V For maintenance purposes, the HV Default can also be set to 0V. In this case, the mechanisms described above are suspended; after a power failure, the measurement begins to get adjusted at 800 V. "HV Default" has already determined and set by BERTHOLD TECHNOLOGIES.

Variable Handling: R/W

Variable Class: Device

Variable Size: 4

Variable DataType: Float

Variable Display Format: |en|.0f

Variable Edit Format: |en|.0f

Variable Unit:

Variable Max:

Variable Min:

Variable Read Command List

Command Number	Command ID	Command Name
163	4205	cmd_rd_detector_setup

Variable Write Command List

Command Number	Command ID	Command Name
164	4206	cmd_wr_detector_startup